Precor 723e owner manual 718e

Diagram 6

Attach base column support to upright support.

Reed switch cable connector

Upright support

Gasket

Base column support (short column)

CAUTION: Make sure you do not crimp the reed switch cable when you tighten the base column support onto the upright support because you could void the manufacturer’s limited warranty.

USA

718e

3.Secure Upper Frame Pieces Together. (Diagram 6) Gently pull the reed switch cable from the top of the upright support as you align the bolt holes in the upright support with the base column support and gasket. Insert the two mid-frame bolts that you set aside in step 2. Thread the bolts through the upright support and into the short column. Fully tighten the bolts using the hex key (G) provided, but be careful not to pinch the cable.

Diagram 7

Install base column support to base frame.

Base column support (short column)

Washer (C)

Base column support mount

Gasket (A)

Bolt (B)

Rear crossbar

4.Attach Base Column Support to Base. (Diagram 7) Place a washer (C) onto each of the two remaining frame-to-base bolts (B). Place the remaining gasket (A) between the base column support mount and the base frame. Align the holes and insert the bolts and washers through the base column support mount and the climber base. Attach a lock nut (D) to the end of each bolt. Hold the lock nut with the wrench (H) while you firmly tighten the bolts with the other wrench (H) provided.

Page 9