![](/images/new-backgrounds/1302733/30273329x1.webp)
Diagram 18
Install the guide rope (718e only).
Pulley
Finger guard
Stair arm
Right stair arm mount
Guide rope (718e only)
c.Loop the rope over the pulley (through the finger guard on both sides of the pulley) and down into the left stair arm mount. See Diagram 18.
Diagram 19
Mark the guide rope (718e only).
Guide rope (718e only)
Pencil or pen mark
Left stair arm mount
CAUTION: Do not stand on | d. | Pull the rope taunt and mark the rope where it meets the stair arm | |
the stair arms while |
| mount. See Diagram 19. | |
performing these steps. Prior |
| Important: Before you mark the rope, be sure that the top of both stair | |
to working out, the tension on |
| ||
| arms line up with the top of the red box on the Precor label. Refer to | ||
the guide rope must be set |
| ||
| Diagram 17 on page 14. | ||
properly to avoid damaging |
| ||
|
| ||
the resistance cylinders and | e. | With the rope running through the stair arm mount, move both stair | |
voiding the manufacturer’s | |||
| arms up so that you can easily tie a knot where you marked the rope. | ||
limited warranty. |
| ||
| Note that if you placed the climber on its side to install the rope, | ||
|
| ||
|
| return the climber to an upright position with the base flat on the | |
|
| floor. | |
| f. | Check the length of the guide rope by returning the stair arms to an | |
|
| even position shown in Diagram 17 on page 14. The top of both stair | |
|
| arms should line up with the red box located on the Precor label. | |
CAUTION: Check the knots | g. | Step onto the stair arms. Test the stair stroke by moving your legs up | |
and the length of the rope |
| and down a few times. | |
before standing on the stair |
|
| |
arms. You cannot |
|
| |
knots once you stand on the |
|
| |
stair arms. |
|
|
Page 15