Precor 835 warranty Attaching the end caps

Assembling the Climber 21

3.Secure the lower handrails using four buttonhead screws and a ⁵₃₂-inch hex key. Fully tighten the fasteners.

4.Using a ¹₂-inch socket wrench, tighten the two nuts beneath the upper handrail clamp until the handrails cannot be pulled out of the clamp.

5.Position the two lower handrail boots so that the lip on each boot faces outward. Slide the boots down onto the rear crossbar.

6.Position the end caps so that they cover the ends of the rear crossbar and the lips on the lower handrail boots. Attach the end caps using two socket head cap screws and a ⁵₃₂-inch hex key. Tighten the fasteners completely.

Important: The lip of each lower handrail boot should fit beneath the end cap.

Figure 10: Attaching the end caps

7.Position the water bottle holder as shown and attach it to the right handrail. Secure the holder using three Phillips-head screws and a Phillips screwdriver.

Figure 11: Attaching the bottle holder