C9x6i Commercial Treadmill Assembly Guide 4
Tie a string to a washer (D) and feed the washer through the
lower side bracket hole in the right upright support. As the
washer falls to the floor, leave the upper end of the string
hanging out the side bracket hole. Remove the washer from the
other end of the string.
Remove any tape or wire ties that secure the display cable.
Unwrap the cable and remove the kinks.
Ask your assistant to hold the display console above the
upright supports while you feed the cable through the right
upright support. Make sure the cable connector rests on the
floor at the base of the upright support.
Lower the display console, align, and secure it to the upright
supports using six buttonhead screws (C) and six washers (D).
Finger tighten.
Important: Do not wrench tighten the screws until the unit
has been fully assembled. Make sure the fasteners do not
pinch the cable. Cables damaged by improper installation will
not be covered by the Precor Limited Warranty.
Tie the string to the cable connector. Pull the cable through the
side bracket hole in the base frame. Remove the string and
then, connect the cable to its receptacle.
Note: An audible click is heard when the cable is properly
attached. Place excess cable inside the upright support.
String with washer.