Precor P/N 300753-201 rev B manual Rear cover removal

18 Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes

3.Remove the three #10 x 1-inch self-tapping screws holding the rear cover in place, then lift it off.

Figure 4: Rear cover removal

4.Remove the three #10 x 1-inch self-tapping screws holding the left side cover in place, then pull the cover away from the body assembly. Guide the cover around the pedal crank, then remove it and set it aside.

Figure 5: Left side cover removal

5.Remove the tape holding the base unit data cable and the heart rate sensor cable in place inside the upright support channel.

6.Slide the jack panel up and out of its bracket in the right side cover.