Precor UBK 800-SERIES warranty Installing the Handlebars, To install the handlebars

20 Assembling and Maintaining UBK 800-Series Upright Exercise Bikes

Installing the Handlebars

After the upright support and the bottle holder are securely in place, install the handlebar assembly and route the heart rate sensor cable through the support.

To install the handlebars:

1.Position the handlebars over the brackets near the top of the upright support, as shown in the following illustration. The open ends of the assembly should face up and forward.

Figure 8: Installing the handlebars

2.Feed the heart rate cable through the nearest end of the bracket and into the upright support.

3.Have your assistant pull the end of the heart rate cable through the console mount at the top of the upright support.

4.Place four ⁵₁₆-inch flat washers onto four ⁵₁₆-inch x ³₄-inch sockethead screws. Place the handlebar assembly onto the brackets and attach the four sockethead screws with their washers. Tighten the screws completely using a ¹₄-inch hex wrench.