Premier Mounts PSD-VHSA installation manual Getting the plasma ready, Step

Getting the plasma ready

WARNING: Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display.

Step 1

NOTE: Refer to the PSM or CTM series installation instructions to secure the mounting bracket to the plasma display.

Set the PSD-VHSA on the floor and loosely install the PP-SPA adapter over the tubes flat side facing out, attach the two (2) M8 x 10 socket head screws to the adapter and slowly drop it to all the way until it touches the base. See figure 1.

PP-SPA	Allen wrench
Adapter

(2) M8 x 10 hex

head screws

Base

Step 2

Choose the proper location for the PSD-VHSA and make sure that the location is weight suitable (see warnings). Using (commercially available) suitable hardware depending on you installation environment the two holes found on the base may be used if needed to fasten the stand to the surface. See figure 2.

PP-SPA

Adapter

Suitable hardware

(commercially available)

Base

Suitable surface

(see warning)

- 5 -