Securing the mounting brackets
DIMPLES
M8
M6
M5
M4
The Griplates™ have M4, M5 M6 and M8 hole patterns to fit the hardware that your flat panel requires.
EXAMPLE: If your plasma uses M8 x 20 Phillip screws. Use the M8 mounting points. See figure 7
Once the mounting brackets are aligned secure the Griplate™ to the flat panel.
The dimples of the top plates have to be facing up and the bottom dimples must be facing down. Use (1) Griplate™ per mounting point. See figure 8.
Phillips screw driver |
|
|
| DIMPLES |
|
| FACING UP |
|
DIMPLES |
|
|
FACING UP | DIMPLES |
|
|
| |
| FACING DOWN | Bottom of flat |
|
| |
|
| panel |
| DIMPLES |
|
| FACING DOWN |
|
| 3/4" |
|
Do not over tighten the mounting hardware.
Leave a ¾” gap on both mounting brackets as shown on this diagram.
- 13 -