Manuals / Premier Mounts / Household Appliance / Indoor Furnishings

Premier Mounts UFM installation instructions Lateral shift adjustment

Models: UFM

1 20

Page 19

Lateral shift adjustment

Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on the bottom of the mounting brackets. Use the foot leveler to adjust your plasma.

See figure 16

Do not over tighten the ¼”-20 screws to the rods.

Lateral shift

To remove the display from the wall simply back off the ¼”-20 screws using a Phillips screwdriver and lift the unit of the wall carefully.

- 19 -

Page 19

Image 19

Premier Mounts UFM installation instructions Lateral shift adjustment

Contents

NORTH AMERICA INSTALLATION INSTRUCTIONS9531-001-000-01 AUSTRALIA, NEW ZEALANDWarnings Contents28.000 Assembly drawingDimensions are in Inches and mm DescriptionFlat panel list Mitsubishi M6 x M8 x M8 x M8 x M8 x 35 Qty M8 Parts listM4 x M4 x M5 x M5 x M5 x M5 x M5 x M6 Qty Qty Qty Qty Qty Qty Qty5/16 Flat washers Parts list con’t1/4 Nylon spacers 1/2 Nylon spacersGriplates Parts list con’tThread depth indicator LevelThread depth Checking the thread depth on your flat panelUsing a pencil lightly mark the center of your flat panel See figure Finding center of the flat panel displayout. See figure Positioning the mounting bracketsLay the left and right mounting brackets stamped arrows facingThe mounting brackets are designed with a center of Match the center of viewing guide with the center lineyou marked in step See figureSecuring the mounting brackets Finding the wood studs behind the wall structure Pilot holes Marking the mounting points on the wallLevel Drill gunUse a minimum diameter of 5/16” x 3” long wood screws Securing the wall plate to wood studsSecuring the wall plate to a concrete wall TOP BOTTOM Securing the flat panel to the wall mountLateral shift Lateral shift adjustmentWarranty