Pressure Systems 9046

©This User’s Manual is a copyright product of Pressure Systems, Inc., 2008

Permission is hereby granted to make copies and distribute verbatim copies of

this manual, provided the copyright notice and this permission notice are preserved on all copies.

Contents

Main Page Table of Contents Our Company Our Warranty Technical Support Merchandise Return Procedures Website and E-Mail Our Firmware Our Publication Disclaimer This page left intentionally blank. 1.0 Introduction 1.1 General 1.1.1 Introduction 1.1.2 Physical Description 1.1.3 Theory of Operation 1.1.3.1 Thermocouple Cold Junction Compensation Universal SCM 2.0 Setup Instructions Use the procedures in this section to set up a Model 9046 module. 2.1 Equipment Required Note 2.2 Computer Preparation Figure 2-1: Network Dialog Box Page 2.3 Module Connection Figure 2-3: Cable Connections Page 2.4 IP Address Assignment Figure 2-4: Network Status Screen Figure 2-5: Network Status (after connection) Page Page 2.5 Set Sensor Type Page 2.6 Read Sensor Type 2.7 Thermocouple Reference Temperature Alarms Page 2.8 Set Temperature Units 2.9 Read Temperature Units 2.10 Write EU Filter Parameter Page 2.11 Read EU Filter Parameter 3.0 Calibration Page Page 4.0 Firmware 4.1 Description of Operation Voltage Thermocouple Resistance Thermistor 4.2 Updating the Firmware Page 5.0 Command Set Page 5.1 Summary Information About All Commands Page Page 5.2 No Operation (Command A) 5.3 Reset (Command B) 5.4 Read Primary Transducer Volts (Command V) Page 5.5 Read Primary Transducer A/D Counts (Command a) Page 5.6 Read Primary Transducer E. U. Data at High Speed (Command b) High-Precision Data aaaabbbbcccc .. pppp Page 5.7 Define/Control Autonomous Host Streams (Command c) Page Page 5.7.1 Command c- Sub-command Index 00: Configure a Host Delivery Stream Page Page Page Page 5.7.2 Command c- Sub-command Index 01: Start Stream(s) Page Page Page Page Page 5.7.5 Command c - Sub-command Index 04: Return Stream Information Page 5.7.6 Command c - Sub-command Index 05: Select Prefix/Data Groups in a Stream Prefix/Data Groups Page Page 5.7.7 Command c - Sub-command Index 06: Select Protocol For Stream Delivery Protocol