Pressure Systems 9046 user manual Table of Contents

Pressure Systems, Inc.Model 9046 User’s Manual

Table of Contents

1.0	Introduction		.........................................................................................................	1
1.1	General			1
	1.1.1	Introduction		1
	1.1.2	Physical Description		2
	1.1.3	Theory of Operation		3
		1.1.3.1	Thermocouple Cold Junction Compensation	3
		1.1.3.2	Open Circuit Detection	4

2.0	Setup Instructions	4
2.1	Equipment Required	5
2.2	Computer Preparation	6
2.3	Module Connection	8
2.4	IP Address Assignment	10
2.5	Set Sensor Type	14
2.6	Read Sensor Type	16
2.7	Thermocouple Reference Temperature Alarms	16
2.8	Set Temperature Units	18
2.9	Read Temperature Units	18
2.10	Write EU Filter Parameter	18
2.11	Read EU Filter Parameter	20

3.0	Calibration	21
4.0	Firmware	23
4.1	Description of Operation	23
4.2	Updating the Firmware	25
5.0	Command Set	27
5.1	Summary Information About All Commands	29
5.2	No Operation (Command ‘A’)	32
5.3	Reset (Command ‘B’)	33
5.4	Read Primary Transducer Volts (Command ‘V’)	34
5.5	Read Primary Transducer A/D Counts (Command ‘a’)	36
5.6	Read Primary Transducer E.U. Data at High Speed (Command ‘b’)	38
5.7	Define/Control Autonomous Host Streams (Command ‘c’)	40
	5.7.1 Sub-command Index 00: Configure a Host Delivery System	43
	5.7.2 Sub-command Index 01: Start Stream(s)	48
	5.7.3 Sub-command Index 02: Stop Stream(s)	50
	5.7.4 Sub-command Index 03: Clear Stream(s)	52
	5.7.5 Sub-command Index 04: Return Stream Information	54
	5.7.6 Sub-command Index 05: Select Prefix/Data Groups in a Stream	56
	5.7.7 Sub-command Index 06: Select Protocol for Stream Delivery	59
Appendix A		63

Page i www.PressureSystems.com