V . C O M F O R T A D J U S T M E N T S
NOTE: Change the seat dump by raising or lowering only one set of towers (front or back).
10.Reinstall the retaining clips from step 8.
11.Remove each screw from the trapeze bars and apply thread lock.
12.Reinstall each screw into the trapeze bars and tighten.
13.Reinstall the seat.
14.Reconnect the controller to the power pod.
15.Reinstall the rear shroud and tighten the fasteners.
Seat Position
You can move the seat forward or rearward by changing the extrusion mounting position.
To change the position:
1.Turn off the power to the controller.
2.Loosen the rear shroud fasteners and remove the rear shroud.
3.Unplug the controller connectors from the power pod.
4.Remove the seat from the power base.
5.Remove both extrusions from the bottom of the seat.
6.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or backward. See figure 15.
7.Fasten the extrusions back onto the bottom of the seat.
8.Reinstall the seat.
9.Plug the controller connectors into the power pod.
10.Reinstall the rear shroud and tighten the fasteners.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 5.
To adjust the recline angle:
1.Pull up on the seatback release lever.
2.Lean forward or backward to the desired position.
3.Release the lever.
SEAT MOUNTING HOLES |
Figure 15. Seat Mounting Holes
26 | www.pridemobility.com | Jazzy 1103 Ultra |
