I I I . Y O U R P O W E R C H A I R

Electronics Tray

The electronics tray is located on the rear of your power chair. The electronics tray is located underneath the rear sliding door. The electronics tray consists of the ammeter, the battery charger plug, the main circuit breaker, accessory connector (optional equipment), and the controller harness connectors.

Ammeter: The ammeter displays the charger’s current output in amps. For more information, see VIII. “Batteries and Charging.”

Charger Power Cord Receptacle: This plug is used whenever your battery needs recharging.

Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batter- ies and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute. Next, push in the circuit breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeatedly, contact your authorized Pride Provider.

Accessory Connector (Optional): This is where the accessory harness connects to the controller (power seat, lighting).

Controller Connector: This is where the controller connects to the power base. The VSI uses a large, 9-pin connector (not shown). The Remote Plus and Europa use smaller, multi-pin communications cable connectors. See figure 6.

CHARGER POWER CORD RECEPTACLE

CONTROLLER CONNECTOR

(REMOTE PLUS SHOWN)

OPTIONAL ACCESSORY

CONNECTOR LOCATION

AMMETER

CHARGERFUSE

MAIN CIRCUIT

BREAKER

Figure 6. Electronics Tray

Jazzy 1122

www.pridemobility.com

15

Page 15
Image 15
Pride Mobility 1122 owner manual Electronics Tray Jazzy