I X . C A R E A N D M A I N T E N A N C E

!The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help it retain its high-gloss appearance.

!Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within the battery well, with the battery terminals facing inward, toward each other. Refer to the frame decal for the correct wiring layout.

!All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

Daily Checks

!With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the center when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect the boot. Do not handle or try to repair it. See your authorized Pride Provider if there is a problem.

!Visually inspect the controller harnesses. Make sure that they are not frayed or cut or have any wires exposed. See your authorized Pride Provider if there is a problem with any of these harnesses.

Weekly Checks

!Disconnect and inspect the controller and the charger harnesses from the electronics tray. Look for corrosion. Contact your authorized Pride Provider if necessary.

!Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.

!Check for proper tire inflation. There should be 35 psi (2.4 bar) in each tire. If a tire does not hold air, see an authorized Pride Provider for replacement of the tube.

!Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your power chair.

To check the brakes:

1.Turn on the controller and turn down the speed level of your power chair.

2.After one second, check the battery condition meter. Make sure that it remains on.

3.Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You must be able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this test three times, pushing the joystick backwards, then left, and then right.

Monthly Checks

!Check that the anti-tip wheels do not rub the ground when you are operate your power chair. Adjust them as necessary. See V. “Comfort Adjustments.”

!Check for extreme wear on the anti-tip wheels. Replace them as necessary.

!Check for drive tire wear. See an authorized Pride Provider for repair.

!Check the rear casters for wear. Replace them as necessary.

!Check the rear forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings replaced. See an authorized Pride Provider for repair.

!Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.

Yearly Checks

Take your power chair to an authorized Pride Provider for yearly maintenance. This helps ensure that your power chair is functioning properly and helps prevent future complications.

48

www.pridemobility.com

Jazzy 1122

Page 48
Image 48
Pride Mobility 1122 owner manual Daily Checks, Weekly Checks, To check the brakes, Monthly Checks, Yearly Checks