Pride Mobility 6000Z 3MP Armrest Width Adjustment, Armrest Height Adjustment, Controller Position

V . C O M F O R T A D J U S T M E N T S

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

To change the armrest width:

1.Locate the two armrest knobs on each side of the arm rest receiver bracket. See figure 17.

2.Loosen the knobs.

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Armrest Height Adjustment

To change the armrest height:

1.Loosen the two setscrews located on the armrest receiver.

2.Raise or lower the armrest to the desired height.

3.Tighten the setscrews to secure the armrest.

Armrest Angle Adjustment

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 17.

2.Loosen the jam nut.

3.Turn the adjusting screw to raise the front of the armrest or to lower the front of the armrest.

4.Tighten the jam nut to lock the adjusting screw into place.

Controller Position

You can position the controller for either left-hand or right- hand use.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 18.

3.Slide the controller into or out of the armrest to the de- sired position.

SETSCREW

Figure 18. Underside of Armrest (Contour Seat)

MOUNTING BLOCK

MOUNTING SCREWS

SETSCREWS

Figure 19. Adjusting Controller Position (Mounting Block)

NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or TRU-Balance Power Po- sitioning System, loosen the setscrews in the mount- ing block, slide the controller in or out to the desired position, then tighten the setscrews. See figure 19.

28 www.quantumrehab.com Quantum 6000Z Series