| V . C O M F O R T A D J U S T M E N T S | |
NOTE: Change the seat dump by raising or lowering |
| |
only one trapeze bar (front or rear). |
| |
10. | Reinstall the retaining clips. |
|
11. | Remove each screw from the trapeze bars and apply |
|
| thread lock. |
|
12. | Reinstall each screw into the trapeze bars and tighten. |
|
13. | Reinstall the seat. |
|
14. | Reconnect the controller to the power base. |
|
15. | Reinstall the rear shroud and tighten the fasteners. |
|
Seat Position Adjustment |
| |
You can move the seat forward or rearward by changing |
| |
the extrusion mounting position. |
| |
To change the position: |
| |
1. | Turn off the power to the controller. |
|
2. | Unplug the controller connector(s) from the power base. |
|
3. | Remove the seat from the power base. | Figure 13. Seat Position Adjustment |
4. | Remove both extrusions from the bottom of the seat. | |
5.Reposition the extrusions on a different set of mounting holes.You must move both extrusions the same number of holes either forward or backwards. See figure 13.
6.Fasten the extrusions back onto the bottom of the seat.
7.Reinstall the seat.
8.Reconnect the controller.
Manual Recline Seatback Adjustment
If your power chair seat is equipped with a reclining seatback, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base.
To adjust the seatback angle:
1.Pull up on the seatback release lever.
2.Move the seatback down or up to the desired position.
3.Release the lever.
24 | www.quantumrehab.com | Quantum 600 Series |
