| V . C O M F O R T A D J U S T M E N T S | ||
Foot Platform Height Adjustment |
| ||
The foot platform height is easily adjusted to several differ- | FOOT PLATFORM BRACKET | ||
ent heights. |
| ||
To raise or lower the foot platform: | FOOT PLATFORM RETAINING PIN | ||
| |||
1. | Remove the quick release fasteners from the foot plat- | QUICK RELEASE | |
| form bracket. See figure 17. | ||
| FASTENERS | ||
2. | Loosen the foot platform securement nut | ||
| |||
3. | Raise or lower the foot platform to the desired height. |
| |
4. | Reinstall the quick release fasteners into the foot plat- |
| |
| form bracket and tighten. | SECUREMENT NUT | |
5. | Tighten the foot platform securement nut. |
| |
Foot Platform Depth Adjustment |
| ||
To adjust the foot platform depth: |
| ||
1. | Remove the quick release fasteners from the foot plat- |
| |
| form bracket. See figure 17. |
| |
2. | Move the foot platform in or out to the desired depth. |
| |
3. | Reinstall the quick release fasteners into the foot plat- | Figure 17. Foot Platform Adjustment | |
| form bracket and tighten. |
| |
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See figure 17. Each quick release fastener consists of a bolt, a lever, and a nut. See figure 18. The lever has a cam on the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release fastener is clamped.
BOLT
NUT
LEVER (FULLY CLOSED)
CAM
To clamp the quick release fastener:
1.Make sure the lever is in the open position.
2.Turn the nut clockwise until it is snug.
3.Rotate the lever until it is in the fully closed position.
UNCLAMPED
LEVER(OPEN)
CLAMPED
NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise
Figure 18. Quick Release Fastener Operation
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key. See figure 17.
To adjust the foot platform angle:
1.Flip up the foot platform and locate the setscrew.
2.Turn the setscrew to raise the front of the foot platform or to lower the front of the foot platform.
Quantum 600 Series | www.quantumrehab.com | 27 |
