V . C O M F O R T A D J U S T M E N T S

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the controller for either left-hand or right-hand use.

WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 12.

3.Slide the controller into or out of the armrest to the desired position.

4.Tighten the setscrew to secure the controller.

To change the controller position:

1.Turn off the power to the controller.

2.Disconnect the controller from the power base.

3.Cut the wire tie(s) securing the controller harness to the armrest.

4.Flip up the armrest so it is perpendicular to the floor.

5.Loosen the setscrew on the controller bracket. See figure 12.

6.Slide the controller out of the armrest.

7.Loosen the setscrew in the other armrest.

8.Place the controller in the other armrest.

9.Tighten the setscrew to secure the controller.

10.Use a wire tie to secure the controller harness to the armrest. See figure 13.

11.Plug the controller into the power base.

NOTE: If your power chair is equipped with a Synergy Seat or TRU-Balance Power Positioning System, refer to the controller adjustment information provided in separate manuals.

26

www.pridemobility.com

Quantum Jazzy 1420 Series

Page 26
Image 26
Pride Mobility INFMANU1206 manual Controller Position, To extend the controller, To change the controller position