V . C O M F O R T A D J U S T M E N T S
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights.
To raise or lower the foot platform:
1.Remove the quick release fasteners from the foot platform bracket. See figure 20.
2.Remove the cap and loosen the foot platform securement nut
3.Raise or lower the foot platform to the desired height.
4.Reinstall the quick release fasteners into the foot platform bracket and tighten.
5.Tighten the nut to secure.
Foot Platform Depth Adjustment
FOOT PLATFORM |
|
RETAINING PIN | SECUREMENT NUT |
FOOT |
|
PLATFORM |
|
BRACKET |
|
QUICK |
|
RELEASE |
|
FASTENERS |
|
SCREW |
|
Figure 20. Foot Platform Adjustment
To adjust the foot platform depth:
1.Remove the quick release fasteners from the foot platform bracket. See figure 20.
2.Move the foot platform in or out to the desired depth.
3.Reinstall the quick release fasteners into the foot platform bracket and tighten.
UNCLAMPED
BOLT NUT
CLAMPED
LEVER (FULLY CLOSED)
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fas- teners. See figure 20. Each quick release fastener con- sists of a bolt, a lever, and a nut. See figure 21. The lever has a cam on the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1.Make sure the lever is in the open position.
2.Turn the nut clockwise until it is snug.
3.Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise one- quarter or
LEVER (OPEN)
CAM
Figure 21. Quick Release Fastener Operation
J6 Series | www.pridemobility.com | 27 |
