Pride Mobility jazzy 1120 owner manual S S E M B L Y, Seat Angle Adjustment, Joystick Installation

V . A S S E M B L Y

SEAT ANGLE ADJUSTMENT

The seatback can be adjusted at four different angles, depending on user preference. A 90º, 102º, 105º, or 107 º angle can be set.

To adjust the seat angle:

1.Use a hex key and a 3/8-in. wrench to remove the adjustable bolt on both seat hinges.

2.Set at desired angle.

3.Reinstall the bolt and tighten.

	FRONT
	SEAT	REAR SEAT TOWERS
	TOWERS
SEAT INSTALLATION (SEAT WITH H-FRAME)
Thestandardseatinstallationmethodincorporatestheseatframe(H-
frame) and four (4) adjustable seatposts located on the power base.

To install the seat:

1. Set the seat on the rear seat towers. See figure 10.

2. Push the seat back and down until the latches engage on the front seat towers. See figure 10.

3.	Plug the controller cable into the connector on the utility tray.
	See figure 11.
4.	Plug the power seat switch cable (if so equipped) into the
	connector on the utility tray.
5.	Secure the controller cable to the armrest receiver with one
	or more wire ties.
6.	Route the cable to ensure that the cable cannot be pinched in	Figure 10. Seat Towers
	the seat hinge.
JOYSTICK INSTALLATION		CONTROLLER CABLE
Depending on the various configurations and options you have
chosen for your Jazzy, it may have been shipped without the joy-
stick installed in the armrest.

To install the joystick:

1.Use a 3/16-in. hex key to loosen the setscrew. See figure 12.

2.Slide the joystick mounting bracket into or out of the armrest to the desired position.

3.Retighten the setscrew.

Figure 11. Controller Cable Connection

16 Jazzy 11202000