Pride Mobility Jazzy 1170XL To adjust the ELR length, To adjust the ELR angle, Anti-tip Wheels

V . C O M F O R T A D J U S T M E N T S

To adjust the ELR length:

1.Remove the two adjustment screws from the side of each leg rest extension. See figure 23.

2.Slide the leg rest up or down to the desired length.

3.Reinstall the two adjustment screws.

To adjust the ELR angle:

1.Push down release lever B. See figure 23.

2.Move the leg rest to the desired angle.

Anti-tip Wheels

The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the following occur:

νWhen coming to a stop, your power chair tips forward excessively.

νThe anti-tip wheels constantly rub the ground.

WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip wheel height! Changing the anti-tip wheel height affects handling under deceleration!

WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s tendency to tilt forward when coming to a stop. You can compensate for this by having your authorized Pride Provider make a small adjustment to the pre- programmed deceleration setting in the controller or by moving the seat assembly farther to the rear of your power chair.

Figure 24. Anti-Tip Bracket (Inner Locknut)

To adjust the anti-tip wheels:

1.Place a wrench on the inner locknut of the anti- tip bracket located right after the shock strut. See figure 24.

2.Turn the locknut counterclockwise to loosen the cam.

3.Place your wrench on the adjustable cam located on the other side of the locknut.

4.	To adjust the anti-tip upward, turn the cam coun-
	terclockwise. To adjust the anti-tip downward, turn
	the cam clockwise. See figure 25.	Figure 25. Anti-Tip Wheel Adjustment (Cam)
5.	Tighten the locknut.

NOTE: Each drive tire must have 35 psi in order for the anti-tip wheels to be properly adjusted.

26 www.pridemobility.com Jazzy 1170XL