V . C O M F O R T A D J U S T M E N T S
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1.Remove the quick release fasteners from the foot plat- form bracket. See figure 17.
2.Move the foot platform in or out to the desired depth.
3.Reinstall the quick release fasteners into the foot plat- form bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See figure 17. Each quick release fastener consists of a bolt, a lever, and a nut. See figure 18. The lever has a cam on the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When the lever is open, the quick release fastener is unclamped. When
UNCLAMPED
BOLT
NUT
LEVER (OPEN)
LEVER (FULLY CLOSED)
CAM
CLAMPED
the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1.Make sure the lever is in the open position.
2.Turn the nut clockwise until it is snug.
3.Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise one- quarter or
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key. See figure 19.
To adjust the foot platform angle:
Figure 18. Quick Release Fastener Operation
JAM NUT
SETSCREW
1. Flip up the foot platform and locate the setscrew. | Figure 19. Underside of Foot Platform |
2.Turn the setscrew counterclockwise to raise the front of the foot platform.
3.Turn the setscrew clockwise to lower the front of the foot platform.
Jazzy 600 Series | www.pridemobility.com | 27 |
