Pride Mobility Jazzy 600 3SP, Jazzy 600 2SP manual Controller Position, To extend the controller

Models: Jazzy 600 3SP

1 44
Download 44 pages 35.76 Kb
Page 26
Image 26
Controller Position

V . C O M F O R T A D J U S T M E N T S

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the controller for ei- ther left-hand or right-hand use.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 16.

3.Slide the controller into or out of the armrest to the desired position.

To change the controller position:

1.Turn off the power to the controller.

2.Loosen the rear shroud fasteners. See figure 6.

3.Remove the rear shroud.

4.Unplug the controller connector(s) from the power base.

5.Cut the wire tie(s) securing the controller cable to the armrest.

6.Flip up the armrest and loosen the setscrew. See figure 16.

7.Slide the controller out of the armrest.

8.Loosen the setscrew in the other armrest.

9.Place the controller in the other armrest.

10.Tighten the setscrew to secure the controller.

11.Use a wire tie to secure the controller cable to the armrest.

12.Plug the controller connector(s) into the power base.

13.Reinstall the rear shroud and tighten the fasteners.

NOTE: If your power chair is equipped with a TRU- Balance Seating System, refer to the controller ad- justment information contained in separate manuals.

Foot Platform Height Adjustment

The foot platform height is easily adjusted to several different heights.

To raise or lower the foot platform:

1.Remove the quick release fasteners from the foot plat- form bracket. See figure 17.

2.Loosen the foot platform securement nut one-half turn.

3.Raise or lower the foot platform to the desired height.

4.Reinstall the quick release fasteners into the foot plat- form bracket and tighten.

5.Tighten the securement nut.

CONTROLLER BRACKET

To extend the controller: SETSCREW

Figure 16. Underside of Armrest

FOOT PLATFORM BRACKET

FOOT PLATFORM RETAINING PIN

QUICK RELEASE FASTENERS

SECUREMENT NUT

Figure 17. Foot Platform Adjustment

26

www.pridemobility.com

Jazzy 600 Series

Page 26
Image 26
Pride Mobility Jazzy 600 3S, Jazzy 600XL Controller Position, To extend the controller, To change the controller position