INSTALLATION
AERATION
ADJUSTMENT
The burner aeration is factory set but may need adjusting due to either the local gas supply, air supply or altitude.
NG: 10mm open
LPG: 10mm open
The aeration adjustment gears are located on the right side of the burner box and can be accessed from the side or from the front when the louvres are removed.
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a)
b)
c)
d)
e )
f)
g)
h)Embers
i)Lava
Note: Install Optional Brick Panels prior to installing logs.
3)Place Rear Log
Pins on Rear Log Support
4)Place the Middle Left Log
To adjust the aeration: use the allen key to turn the turning gear which will adjust the air shut- ter. Open the air shutter for a blue flame or close it for a yellower flame. This adjustment is performed by an authorized installer. The fac- tory setting should be sufficient for most instal- lations.
Clockwise to open,
Caution: Carbon will be produced if the air shutter is closed too much.
Note: Any damage due to carboning re- sulting from improperly setting the aeration controls is NOT cov- ered under warranty.
The "02" refer numbers (i.e.
molded into the rear of each log.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the embers on the left and right sides of the firebox base.
EmbersEmbers
5)Sprinkle some lava rock just in front of B)
lava rock
6)Place Front Left Log
FG37 Regency Rear Flued Room Sealed Freestanding Gas Heater | 15 |
