V . C O M F O R T A D J U S T M E N T S

Manual Recline Seatback Adjustment

If your power chair is equipped with a manual recline seatback, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 5.

To adjust the recline angle:

1.Pull up on the seatback release lever.

2.Lean forward or backwards to the desired position.

3.Release the lever.

Seatback Angle Adjustment

If your power chair is equipped with a limited-recline seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.

To adjust the seatback angle:

1.Remove the adjusting screws from each seat hinge. See figure 14.

2.Set the seatback at the desired angle.

3.Reinstall the adjusting screws to each seat hinge and tighten.

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

To change the armrest width:

1.Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 14.

2.Loosen the knobs.

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 14.

2.Loosen the jam nut.

3.Turn the adjusting screw to raise the front of the armrest or to lower the front of the armrest.

4.Tighten the jam nut to lock the adjusting screw into place.

JAM NUT

ARMREST

ANGLE

ADJUSTMENT

SCREW

ARMREST KNOB

ARMREST

HEIGHT

ADJUSTMENT

SETSCREWS

SEATBACK

ANGLE

ADJUSTMENT

SCREW

Figure 14. Seatback/Armrest Adjustment

26

www.pridemobility.com

Jazzy Select Series

Page 26
Image 26
Pride Mobility Jazzy Select 6 Manual Recline Seatback Adjustment, Seatback Angle Adjustment, Armrest Width Adjustment