Pride Mobility Legend 4-Wheel Scooter owner manual Seatback Adjustment, Armrest Angle Adjustment

V I I I . C O M F O R T A D J U S T M E N T S

SEATBACK ADJUSTMENT

WARNING! Do not operate your scooter with the seatback in a reclined position. WARNING! Always keep your back pressed firmly against the seat back while adjusting it.

To adjust your Legend's reclining seat, perform these steps. See figure 10A.

1.While pulling up on the seatback adjustment lever, lean forward or backward to adjust the seatback.

2.Release the seatback adjustment lever once the seat is in a comfortable riding position.

ARMREST ANGLE ADJUSTMENT

The armrests of your scooter can be adjusted upward or downward. See figure 10B.

νBy turning the adjustment dial, the armrest will either raise or lower.

NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.

ADJUSTMENT

DIAL

Figure 10A. Seatback Adjustment Lever Figure 10B. Armrest Angle Adjustment

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to different heights. See figure 11.

1.Remove the seat and shroud from your Scooter. See IX. “DisassemblyandAssembly.”

2.Loosen the seat height adjustment bolt-nut and remove it from the bolt. Remove the bolt and washers.

3.Loosen the seat post bolt.

4.Raise or lower the upper seat post to the desired seat height.

5.While holding the upper seat post at that height, match up the locating holes in the upper seat post with those of the lower seat post.

6.With one washer on the seat height adjustment bolt insert it through the locating holes of both the upper and lower seat posts. Reinstall the other washer and bolt-nut and tighten.

SEAT HEIGHT ADJUSTMENT BOLT—NUT

SEAT POST BOLT—NUT

UPPER SEAT POST

LOCATING

HOLES

SEAT HEIGHT ADJUSTMENT BOLT

NOTE: Ensure both washers have been reinstalled before fully tightening the bolt-nut.

7.Tighten the seat post bolt

8.Reinstall the rear shroud and the seat.

SEAT POST

BOLT

LOWER SEAT POST

Figure 11. Seat Height Adjustment

30 www.pridemobility.com Legend