Pride Mobility Legend 4-Wheel Scooter owner manual X I . B A S I C T R O U B L E S H O O T I N G

X I . B A S I C T R O U B L E S H O O T I N G

Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FLASH CODES

Thediagnosticflashcodesforyourscooteraredesignedtohelpyouperformbasictroubleshootingquicklyandeasily. AdiagnosticflashcodewillflashfromthestatusLEDintheeventoneoftheconditionslistedbelowdevelops.

NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been turned off, then turned back on.

FLASH CODE

CONDITION SOLUTION

(1)￿￿

(2)￿￿￿

(3)￿￿￿￿

(6)￿￿￿￿￿￿￿

(7)￿￿￿￿￿￿￿￿

(8)￿￿￿￿￿￿￿￿￿

(9)￿￿￿￿￿￿￿￿￿￿

(10)￿￿￿￿￿￿￿￿￿￿￿

Batteries are too low to operate the scooter or the charger is operating.

Motor disconnected.

Motor wiring fault.

Scooter is operating with the charger attached.

Throttle potentiometer fault.

Internal controller fault.

Brake fault—your scooter was left in freewheel mode.

High battery voltage. The batteries have been overcharged and the scooter won’t run.

Charge batteries or unplug the charger power cord from the electrical outlet.

Check all connections to the motor.

Call your authorized Pride Provider for assistance.

Unplug the charger power cord from the charger power cord receptacle.

Call your authorized Pride Provider for assistance.

Call your authorized Pride Provider for assistance.

Turn the scooter key to the off position, then push the manual freewheel lever to the (down) drive position, and restart your scooter.

Leave the scooter turned on to drain the batteries to a sufficient level. If the batteries continue to overcharge call your authorized Pride Provider for assistance.

What if all the systems on my scooter seem to be “dead”?

νMake certain that the key is in the “on” position.

νCheck that the batteries are fully charged. See VI. “Batteries and Charging.”

νPush in the main circuit breaker reset button. SeeV. “Your Legend.”

νMake certain that both battery harnesses are firmly connected to the rear electronics module and to the battery terminals. See IX. “Disassembly andAssembly.”

νMake sure that the front-to-rear harness is firmly connected to the rear electronics module. See IX. “Disas- semblyandAssembly.”

νCheck the 3-amp fuse located on the lower portion of the tiller console. See XII. “Care and Maintenance” for fusereplacement.

νBesurethePowerDownTimerfeaturefeaturehasn’tbeenactivated.

What if my scooter does not move when I press the throttle control levers?

νWhenthemanualfreewheelleverispulledup,thebrakesaredisengagedandallpowertothemotor/transaxleassemblyiscut.

νPush down on the manual freewheel lever, turn the scooter off, and then turn the scooter on to return to normal scooter operation.

36 www.pridemobility.com Legend