V I I I . C O M F O R T A D J U S T M E N T S
SEATBACK ADJUSTMENT
The seatback may be positioned to four different angles: 90°, 100°, 102° and 105°. See figure 12.
To adjust the seatback angle:
1.Loosen and remove the adjustment screws from the seatback hinge on both sides of the seat.
2.Reposition the seatback to the desired angle.
3.Align the adjustment holes from the upper and lower hinge, so the adjustment screw can easily pass through.
4.Reinsert both adjustment screws and tighten.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 13.
1.Remove the seat and rear shroud from your scooter. See IX. “Disassembly andAssembly.”
2.Loosen the nut and remove it from the bolt, and remove the bolt and washers from the lower seat post.
3.Raise or lower the upper seat post to the desired seat height.
4.While holding the upper seat post at that height, match up the holes in the upper seat post with those of the lower seat post.
5.Fully insert the bolt, reinstall the washers, and tighten the nut.
Note: Ensure both washers have been rein- stalled before fully tightening the nut.
6. Reinstall the rear shroud and the seat.
UPPER HINGE
100° ADJUSTMENT HOLE
ADJUSTMENT SCREW
102° ADJUSTMENT HOLE 
105° ADJUSTMENT HOLE
90° ADJUSTMENT HOLE
LOWER HINGE
Figure 12. Seatback Hinge
UPPER SEAT POST
WASHER
WASHER
BOLT
NUT
LOWER SEAT POST
Figure 13. Seat Height Adjustment
Maxima | www.pridemobility.com | 29 |
