I I I . Y O U R S C O O T E R

Throttle Control Lever

This lever allows you to control the forward speed and the reverse speed of your scooter up to the maximum speed you preset with the speed adjustment dial.

To Move Forward, use either of the following: Use your left thumb to push the left side of the throttle control lever.

Use your right hand fingers to pull back on the right side of the throttle control lever.

To Move Rearward, use either of the following: Use your right thumb to push the right side of the throttle control lever.

Use your left hand fingers to pull back on the left side of the throttle control lever.

Release the throttle control lever and allow your scooter to come to a complete stop before engaging the other side of the lever. When the throttle control lever is completely released, it automatically returns to the center “stop” position and engages your scooter’s brakes.

Off-board Charger Port

The off-board charger power cord plugs into this port during battery charging. The off-board charger port will be located on the tiller. See figure 5.

Electrical System Fuses

Your scooter is equipped with a series of electrical sys- tem fuses, which help protect the off-board charging system, key switch, and lighting system from receiving an overload of electrical current. These fuses are the same type used in automobiles and are located in a compartment on the tiller. See figure 6. See IX. “Care and Maintenance” for fuse replacement.

NOTE: Keep all electrical areas clean and free of moisture and foreign material.

OFF-BOARD

CHARGER PORT

Figure 5. Off-board Charger Port (Tiller Mounted)

OFF-BOARD CHARGER

KEY SWITCH

LOWER HEADLIGHT

REAR TAIL LIGHTS

LEFT TURN SIGNAL

RIGHT TURN SIGNAL

Figure 6. Tiller Console Fuses

V10

www.pridemobility.com

21

Page 21
Image 21
Pride Mobility v10 manual Throttle Control Lever