Pride Mobility v10 manual I . D I S a S S E M B L Y a N D a S S E M B L Y, Disassembly

V I I . D I S A S S E M B L Y A N D A S S E M B L Y

DISASSEMBLY

You can disassemble the scooter into several pieces: the seat, the front section, the rear section, the battery shroud (if equipped), the basket, and the batteries or battery boxes. See figure 20. No tools are required to disassemble or assemble your scooter, but keep in mind that the disassem- bled sections of the scooter take up more floor space than the assembled unit. Always disassem- ble or assemble your scooter on a level, dry sur- face with sufficient room for you to work and move around your scooter–about 5 feet (1.5 meters) in all directions. Remember that some scooter components are heavy and you may need assistance when lifting them.

WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary

while disassembling or assembling your scooter.

1.Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up on the seat.

2.Gently pull the battery shroud up and off of the scooter.

3.Disconnect the battery tie-down strap.

4.Unplug both battery harnesses by pulling each harness straight up. See figure 21.

5.Remove the batteries from the battery wells.

FRONT SECTION	SEAT
	REAR SECTION
BASKET	BATTERIES
	BATTERY SHROUD

Figure 20. Scooter Components

BATTERY HARNESS CONNECTIONS BATTERY TIE-DOWN STRAP

Figure 21. Harness Connections

WARNING! Failure to unplug both battery harnesses prior to separating the front and rear sections could result in permanent damage to the scooter.

36 www.pridemobility.com V10