I I I . I N S T A L L A T I O N

14.Simultaneously press the two microswitches on the Backpacker tower arm and the “DOWN” button on the hand control until the tower reaches its full extension. See figure 2.

15.Release the microswitches, then press the “UP” but- ton on the hand control to retract the tower arm.

16.Insert the T-Bar into the lift tower and secure into position with the supplied hardware. See figure 3.

17.Push the “UP” button on the hand control to raise the platform frame to its highest position.

18.Inspect the clearance between the bumper and the platform frame.Appropriate clearance is necessary in order to slide the platform into the vehicle.

NOTE: If there is not adequate clearance between the bumper and the platform frame, you may need to install an end support bracket. Remove the Back- packer from the van and install the end support bracket close to the rear door opening. Reinstall the lift into the van, making sure that the bolts protrud- ing from the bottom plate of the Backpacker closest to the van door snap into the tapped holes on the top of the end support bracket, then repeat steps 13 through 18.

NOTE: It may be required to trim the rear inside sill to achieve the adequate platform clearance with the platform under load.

19.Attach the lift platform to the lift frame. Refer to the installation instructions supplied with your lift platform.

20.Drape the Y-strap over the platform and secure the lock assembly to the lift platform. See figure 4.

21.Fully tighten all mounting hardware throughout the lift system once the unit has been centered and all re- quired clearances have been achieved.

22.Run the Backpacker through an entire lift cycle. Lower the platform to the ground and then raise the platform to the fully stowed position in the van. See IV. “Operation.”

LIFT TOWER

T-BAR

Figure 3. T-Bar Installation

LOCK ASSEMBLY

Figure 4.Y-Strap Installation

NOTE: Pay attention to the path of the lift platform during operation. Make sure the lift does not rub against or interfere with the vehicle in any way. If you notice any contact between the lift platform and the vehicle, stop lift operation immediately and contact your authorized Pride Provider for assistance.

10

www.pridemobility.com

Backpacker

Page 10
Image 10
Pride Mobility Wheelchair/Scooter Lift manual Bar