I I I . I N S T A L L A T I O N

WARNING! Release the “DOWN” button when the lift platform touches the ground. Do not allow the motor to run after the lift platform has touched the ground. Allowing the motor to run will increase the pressure on the lift platform and may result in product or vehicle damage.

Wiring Harness Installation

The wiring harness is approximately 25 ft. (7.62 meters) long and will accommodate most vehicles.

NOTE: You may wish to perform a practice run before installing the wiring harness. Route a piece of light rope (equivalent to the gage of the wiring harness) along the anticipated path observing contact points, potential rubbing/chafing points, and any sharp edges. Remove sharp edges with a fine grade file, then treat the steel with a rust inhibitor or metal sealant.

Follow these steps to route the Backpacker wiring harness:

1.Route the lift system wiring harness (starting at the lift) through the interior of the vehicle until you reach the vehicle battery. See figure 5.

WARNING! Avoid routing the wire harness where it will interfere with or become pinched by the securement system floor plates.

2.Conceal the harness behind or under the interior panels (there should be existing holes). Be certain that the harness is protected with a rubber grommet when passing it through the metal panels and into the engine compartment.

3.Inside the engine compartment, secure the harness to the firewall and the inner fender with plastic wire ties. Use care not to cause abrasions to the wiring harness. It is important to secure the wiring harness at various points along its run of the vehicle.

WARNING! Do not cut or shorten the wiring harness. If the harness is too long, coil the excess wire and secure it with plastic wire ties.

4.Remove the 15-amp fuse from the wiring harness. See figure 5.

5.Connect the red wire to the positive (+) terminal and the black (grounding) wire to the negative (-) terminal of the vehicle battery.

HAND CONTROL

 

GROUNDINGWIRE

 

FUSE

 

WIRING HARNESS

 

VEHICLE BATTERY

LIFT WIRING CONNECTION

Figure 5. Wiring Harness Installation

 

Backpacker

www.pridemobility.com

11

Page 11
Image 11
Pride Mobility Wheelchair/Scooter Lift manual Wiring Harness Installation