V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
To release the toggle latch:
1.Push in the toggle latch release button while pulling back the toggle latch. See figures 20 and 21.
2.Position the toggle latch buckle over the top of the toggle latch. See figure 22.
3.Lower the tiller to the scooter floorboard.
TOGGLE LATCH RELEASE BUTTON
TOGGLE LATCH
TOGGLE LATCH BUCKLE
Figure 20. Toggle Latch (Latched) | Figure 21.Toggle Latch (Unlatched) | Figure 22. Buckle Secured |
To separate the frames:
1.Push back on the seat post to pivot the rear section rearwards until the rear section is standing vertically on its bumper. See figure 23.
2.Lift the front section up until the lower pegs are no longer in the slots. See figure 24.
3.Carefully move the front section away from the rear section.
ASSEMBLY
1.Position the front and rear sections of your scooter as shown in figure 24.
2.Alignthelowerslotsofthefrontsectionwiththecorresponding pegs on the front of the rear section. See figure 24.
WARNING! Position the
3.Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully connected onto the top rear pegs.
4.Raise the tiller.
5.Secure the toggle latch. See figure 21.
!Lower the toggle latch buckle.
!Push back on the toggle latch so it locks into place.
6.Connect the
7.Reinstall the shroud.
8.Reinstall the seat, and lock it into place.
Figure 23. Frame Positioning
PEG CURVED LOCKING BRACKET
Figure 24. Frame Sections
32 | www.pridemobility.com | Legend Classic |
