CLEANING
DAILY
1Teflon sheets should be rotated and cleaned on a daily basis. NOTE: Do not use sharp objects to clean Teflon sheets.
2.Wipe conveyor belt with a damp cloth on a daily basis. Remove front cover/bun chute assembly to access the conveyor belt. NOTE: Do not use sharp objects to clean the conveyor belt.
MONTHLY
1.Conveyor belt should be removed and cleaned thoroughly on a monthly basis.
2.Remove front cover/Bun Chute Assembly by pulling up and off of the toaster and set aside.
3.Loosen thumbscrews and remove left side panel.
4.Press down on conveyor belt upper roller and lock into position.
5.Release upper and lower locking latches from the conveyor rollers.
6.Remove conveyor belt from the unit. It is easier to remove the belt by turning it as you pull it from the side.
6.Place belt on a flat surface, being careful not to crease the loops.
7.Clean with hot soapy water and sponge, then let air dry.
8.Reverse steps
CONVEYOR BELT TRACKING ADJUSTMENT
The Conveyor belt tracking adjustment allows for adjusting the conveyor belt if it slides too far to either side of the conveyor. Adjustment screw is located on the left side of the unit by the upper locking latch.
1.If the conveyor belt slides too far to the right, loosen the nut, then turn the adjustment screw clockwise to tighen, this will move the belt back to the center. Tighten the nut to lock the adjustment screw into place.
2.If the conveyor belt slides too far to the left, loosen the nut, then turn the adjustment screw counter clockwise to loosen, this will move the belt back to the center. Tighten the nut to lock the adjustment screw into place.
4
