README FIRST
Thank you for purchasing the Princeton T series monitor. These easy
USING W ITH A DESKTOP PC or LAPTOP:
1.Prior to connecting the T monitor, if you have a desktop monitor connected to your PC,
please ensure that the video card refresh rate is set within the T frequency range by going to: Start…Settings…Control Panel…Display…Settings…Advanced…Adapter.
Set the Adapter refresh rate to 60Hz or “Adapter Default”. See Appendix B, page 20 for details onresolution/refreshrates.
This applies to the three supported resolutions of 640×480, 800×600 and 1024×768.
Otherwise, the monitor will not display and the unit will go into standby mode
(Yellow -orange LED).
2Plug the power cord into the AC input on the rear of the T monitor, then plug the power cord into a
3. Connect the VGA cable provide from your computer’s VGA output to the input on the Monitor.
VGA 1 is the VGA input port located in the rear of the monitor. VGA 2 is the VGA input port located in front of the monitor. Be sure the PC is powered on before the monitor.
Press the VGA1/VGA2 select button, located next to the front VGA connector and on the Remote Control until the computer image is displayed.
SIMULTANEOUS VIEWING OF THE MONITOR AND STANDARD PC MONITORS:
1.Connect the VGA cable from the PC’s VGA output to the VGA input.Then plug the desktop monitor’s VGA cable to the monitor VGA output.
USING WITH A LAPTOP:
If you are using Notebook: Press Fn + F5 (or Fn+F3) to output the display to CRT only ( CRT output combination key may be different on some notebooks), or press combination key again to show on both CRT and LCD display.
USING WITH A MAC:
1.Plug the AC power cord from the power source (outlet) to the AC input of our monitor.
2.Connect the MAC adapter to the MAC monitor output (if required by the MAC model). Refer to the adapter user’s manual for the proper dip switch settings. The optimum setting for the monitor is a resolution setting of 800 x 600 and a refresh rate of 75Hz. Make sure the display settings of the MAC is set to 800 x 600 at 75Hz as well.Note: You need a MAC adapter when using the monitor with older MAC Computers. The MAC adapter converts the output to VGA
3.Connect the VGA cable from the monitor tohetMACadapter.
USING WITH A VIDEO SOURCE or Cable TV ( DVD Player / VCR / LD Player ):
Pling refer to the T Use’s Manual
2
FCC STATEMENT
This equipment has been tested and found to comply within regulations for a Class B digital device, pursuant to Part 15 of the FCC rules. These regulations are designed to provide protection against harmful interference in a residential installation. This equipment can generate, use and radiate radio frequency energy and if not installed and/or used in accordance with the instructions provided, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipmentand receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for assistance.
Warning:
Only use shielded cable to connect I/O devices to this equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate this equipment.
3
