Continuous, Tear-Off, and Tear-Off Strip
27
Adjust The Scanning Beam
NOTE: Make sure the printer is on and the scanning beam is on. If
the beam is off, press the RESET button for less than 2
seconds to turn on the beam.

Continuous, Tear-Off, and T ear-O ff St rip

When the validator is first installed, the scanning beam m ay need to
be aligned with the two notches on the sides of the tear bar, as
shown in Detail A of Figure11. When the scanning beam is
properly aligned it will line up with the two notches.
Figure 11. Aligning the Scanning Beam: Continuous, Tear-Off, and Tear-Off Strip
Media Handling Modes Only
A
t5lsrlc2
June 19
,
2000
A
Notch in Tear Bar
Scanning Beam