OPERATING HEATER
Continued
3.After completion of the
OPERATIONS OF
when the burner is in operation or the transmitter is in a state of readiness, just press LOCK button on the operating panel, there will be a “” symbol on the LCD. If any button is pressed now, the burner will not react at all.
when the burner is in a state of
OPERATIONS OF
FAN
There are three selections: “AUTO” “MAN” and “OFF”.When pushing the “FAN” button on the “AUTO” select, the fan will be controlled by the thermostat on the fan blower unit. On the “MAN” select, the fan will be kept in operation.To stop the operation, push the “FAN”button to “OFF”select.(See Fig16)
INSPECTING BURNERS
C h e c k p i l o t f l a m e p a t t e r n a n d burner flame patterns often.
PILOT FLAME PATTERN
Figure 17 shows a correct pilot flame pattern. Figure 18 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple.This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
If | pilot flame pattern is incorrect, as shown |
in | Figure 14: |
| t u r n h e a t e r o f f ( s e e To Tu r n |
| Off Gas to Appliance, page 9) |
| see Troubleshooting (pages 12 |
| through 13). |
Figure 19 shows a correct burner flame pattern. Figure 20 shows an incorrect burner flame pattern. If burner flame pat- tern is incorrect:
turn heater off (see To Turn Off Gas to Appliance, page 9) see Troubleshooting, pages 12 through 13
9
20
CLEANING AND MAINTENANCE
WARNING: Disconnect power be-
fore attempting any maintenance or cleaning to reduce the risk of fire , elec- tric shook or personal injury. Turn off heater and let cool before cleaning.
CAUTION:Label all wires prior to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
DISCONNECT WIRNG OR CONTROL MODULE1.Remove four screws from the rear control panel , take out thermostat sensing bulb from the clip, then disco- nnect the wires to free to control module from its mounting location . Note: Do not confuse the mark on the each wire.
2.Remove two screws and hex nuts, take out the control module. When in-
stalling , reverse the steps above. (See Figure 22 and Figure 25 )
Figure 22- Control ModelDISCONNECT FAN1.Remove screws from the fan bracket panel , pull the fan bracket panel out to remove. Then disconnect two wires free to fan.
2.Mark or tag each wire removed for its exact reconnection. Remove the four
screws from the fan .when installing , reverse the steps above.(See Figure23 and Figure 25)
21
1 2