MAINTENANCE OF MOTORS
The motors used on the fan and flame genera- tor assembly are prelubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit is recommended.
WARNING: Make sure that the power is turned off before proceeding.
GLASS INFORMATION
1.Under no circumstances should this product be operated with missing or broken glass.
2.Do not strike or slam the glass.
3.Do not use abrasive cleaners to clean the glass.
4.Replacement glass is available from the manu- facturer and replacement should be carried out by a qualified service person.
SERVICE INSTRUCTIONS
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury.
REPLACING LIGHT BULBS
This fireplace uses clear 220 Volt, 60 Watt,
1.Turn off power to the unit by unplugging the power cord.
2.Let fireplace cool if it has been operating.
3.Remove the two screws on the top corner of screen. Pull the screen upward slightly, and then pull out.
Note: SFE23RE uses three lights bulbs. SFE33RE uses four lights bulbs.
4.Remove the four screws that secure the log set/em- ber bed in position.
5.Remove log set / ember bed and grate assembly.
6.Examine the bulb(s) to determine which bulbs need to be replaced.
7.While holding the socket, unscrew defective bulb(s) counterclockwise.
8.Install the new light bulb(s) by holding the socket and screwing clockwise.
9.Reinstall the log set/ember bed, grate assembly and screen. Follow the above procedure in reverse order.
WARNING: Do not exceed 60 Watts per bulb. The use of higher rated bulbs may result in a fire causing 
property damage and personal injury.
5
