SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, and injury, please follow these basic safety precautions before you use this equipment.
1.Carefully read the instructions in this manual.
2.Follow all warnings and instructions marked on the unit.
3.When cleaning, unplug the telephone jack from the wall outlet. Use a damp cloth. DO NOT use liquid or aerosol cleaners.
4.Do not use this equipment near water, eg: near a kitchen sink, bathtub, washbowl, laundry rub, swimming pool or in a wet basement.
5.Install in a protected location. Ensure all lines and cords are away from foot traffic. DO NOT place objects on the line cord that may cause damage or abrasion.
6.Avoid spilling any liquid on the unit. This may cause internal shorting, fire or shock and is not covered under your warranty.
7.Do not overload wall outlets and extension cords as this can result in the risk of fire or electrical shock.
8.Never push objects of any kind into this telephone as they can touch dangerous voltage points or short out parts that could result in a risk of fire or electrical shock.
9.Take the phone to a qualified technician when it requires repair work or service. To reduce the risk of electrical shock, do not disassemble the telephone. Opening or removing covers can expose you to dangerous voltages or other risks. Incorrect re- assembly can cause electrical shock during subsequent use.
10.Avoid using the telephone during an electrical storm. There can be a slight risk of electrical shock from lightning.
11.DO NOT use the telephone to report a gas leak, if in the vicinity of the leak.
12.Unplug this telephone from the wall outlet and refer servicing to qualified service personnel under the following conditions:
If liquid is spilled into the unit.
If the unit is exposed to rain or water.
If the unit does not operate normally by following the operating Instructions.
If the unit is dropped or the casing is damaged.
If the unit exhibits a distinct change in performance.
|
| TROUBLESHOOTING |
| |
| If you have problems with your phone, please check below | |||
| for helpful hints: |
| ||
BLANK OR | Check the line cord. Connect the telephone cord. Check | |||
FAINT |
| batteries, Check adaptor. |
| |
SCREEN |
|
| ||
|
|
| ||
CALLER ID | Call your telephone company to verify that your Caller ID | |||
WILL NOT |
| services are active. |
| |
WORK |
|
| ||
|
|
| ||
PROPERLY | You may have too many communication devices hooked | |||
PHONE | ||||
| to a single line. A communication device can be a phone, | |||
WILL NOT |
| |||
| modem or facsimile (FAX) machine. Contact | your | ||
RING |
| |||
| telephone company for help in calculating the limit | for | ||
|
| |||
|
| your residence or business line. |
| |
NO DIAL | Verify that the line cord is plugged in correctly. |
| ||
TONE | Verify that the line cord connection is correct and tightly | |||
|
| secured. |
| |
NO DATA | Call your telephone company to verify that your caller ID | |||
| services are active. |
| ||
SENT |
|
| ||
If you have an answering machine connected to this | ||||
| ||||
|
| Phone, ensure that your answering machine is set to | ||
|
| answer after at least two rings. |
| |
| You answer the call before two rings. |
| ||
| Contact your telephone company if the problem | |||
|
| continues for more than 24 hours. The telephone | ||
|
| company may be experience temporary line. |
| |
NO RE- | If you have experienced a power failure when using | |||
SPONSE ON | optional AC adaptor, the batteries for memory back up | |||
LCD DISPLAY | could become weak or dead. If the power is restored and | |||
|
| the display screen does not respond then You must | ||
|
| replace the batteries with new ones. |
| |
2 | 19 |
