ProForm 1080 warranty Top, Problem The walking belt slows when walked on

Models: 1080

1 40
Download 40 pages 1.57 Kb
Page 30
Image 30

Locate the Reed Switch (52) and the Magnet (50)

 

 

on the left side of the Pulley (49). Turn the Pulley

 

 

until the Magnet is aligned with the Reed Switch.

 

 

Make sure that the gap between the Magnet and

52

49

the Reed Switch is about 1/8 in. (3 mm). If nec-

essary, loosen the #8 x 3/4" Tek Screw (14), move

14

50

the Reed Switch slightly, and then retighten the

1/8 in.

 

Screw. Reattach the Motor Hood (not shown) and

 

 

run the treadmill for a few minutes to check for a

Top

 

correct speed reading.

 

 

View

 

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. Recalibrate the incline system (see step 3 on page 26).

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 15.

b. If the walking belt is overtightened, treadmill perfor-

b

 

mance may decrease and the walking belt may be-

2–3 in.

come damaged. Remove the key and UNPLUG

 

THE POWER CORD. Using the hex key, turn both

 

 

idler roller bolts counterclockwise, 1/4 of a turn.

 

 

When the walking belt is properly tightened, you

 

 

should be able to lift each edge of the walking belt

 

 

2 to 3 in. (5 to 7 cm) off the walking platform. Be

 

 

careful to keep the walking belt centered. Then,

 

 

plug in the power cord, insert the key, and run the

Idler Roller Bolts

treadmill for a few minutes. Repeat until the walking

belt is properly tightened.

 

 

c. If the walking belt still slows when walked on, see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

 

 

SOLUTION: a. If the walking belt is off-center, first remove the

a

 

key and UNPLUG THE POWER CORD. If the

 

walking belt has shifted to the left, use the hex

 

 

key to turn the left idler roller bolt clockwise 1/2 of a

 

 

turn; if the walking belt has shifted to the right,

 

 

turn the left idler roller bolt counterclockwise 1/2 of

 

 

a turn. Be careful not to overtighten the walking

 

 

belt. Then, plug in the power cord, insert the key,

 

 

and run the treadmill for a few minutes. Repeat

 

 

until the walking belt is centered.

 

 

30

Page 30
Image 30
ProForm 1080 warranty Top, Problem The walking belt slows when walked on, Turn if the walking belt has shifted to the right