5.While a second person holds the console as- sembly near the Handrail (20), attach the ground wire to the indicated hole in the Handrail with a Ground Screw (33).

6.While the second person continues to hold the console assembly, locate the wire harness un- derneath the console assembly.

Connect the wire harness from the console as- sembly to the Upright Wire Harness (77). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try again. IF THE CONNECTORS ARE NOT CON-

NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors down- ward into the Handrail (20).

7.Set the console assembly on the Handrail (20).

Be careful to avoid pinching any of the wires. Make sure that the ground wire (see step 5) and the wire harness from the console as- sembly (see step 6) are in the indicated chan- nel.

Hand tighten five Screws (3) into the Handrail (20) and the console assembly. Start all five

Screws, but do not tighten them yet. Do not put Screws into the two indicated holes.

5

 

 

 

Ground

 

 

Wire

 

 

33

 

 

Hole

 

 

20

 

 

 

Console

 

 

Assembly

6

 

 

 

Wire

77

Console

77

 

Assembly

 

 

 

20

 

7

 

 

Console Assembly

Channel

20

3 3 3

No Screws

8

Page 8
Image 8
ProForm 480 CX user manual No Screws