11.Raise the Shock (92) to a vertical position. | 11 |
|
Remove the Shock Pin (25) from the raised end | 58 |
|
of the Shock as described in step 6. If neces- | Bracket | |
sary, rotate the Shock to align the end of the |
| |
|
| |
Shock with the ball on the bracket on the Frame |
|
|
(58). |
|
|
| 25 |
|
Next, press the Incline increase and decrease |
| 92 |
buttons until the ball on the bracket is aligned |
|
|
with end of the Shock (92). Then, press the end |
|
|
of the Shock onto the ball. Note: It may be nec- |
|
|
essary to press the end of the Shock onto the |
|
|
ball while the Frame is moving. | 11a |
|
|
| |
See drawing 11a. Insert the Shock Pin (25) into |
|
|
the two indicated small holes in the end of the |
|
|
Shock (92). Then, rotate the Shock Pin until it | Holes |
|
clips onto the Shock. Note: Extra Shock Pins are |
| |
|
| |
included. |
|
|
Press the Incline decrease button until the | 25 | 92 |
| ||
|
| |
treadmill is at the lowest incline level. Then, |
|
|
unplug the power cord and lower the treadmill |
|
|
Frame (58) to the floor. |
|
|
12.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver included with the chest pulse sensor.
1.Remove the key from the console and unplug the power cord.
Remove the Screw (3) and the Access Door (76) from the back of the Console Base (85).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base
(85). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (76) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver.
85 |
|
Small Screws |
|
A | Wire |
| |
Small |
|
Cylinder |
|
76 | 3 |
10
