Assemble Pendant Light
1.Route light fixture wires through mounting rod (threaded end first) that will connect to the fixture.
2.Screw rod into light fixture. Tighten mounting rod securely.
3.Continue this process until desired number of mounting rods are connected to light fixture
(including the rod connected to the canopy). IMPORTANT: TIGHTEN all connections securely.
Note: If necessary, trim away any excess thread sealant for best appearance.
Fixture Bare
Ground Wire
Canopy
Mounting Rod (Attached to Canopy)
Light Fixture Wiring
First Mounting Rod
2.Trim light fixture wire length if needed.
3.Connect the junction box wires and the fixture wires together as shown in the following dia- gram.
4.Twist and secure wires with wire nuts.
IMPORTANT: This light fixture is polarized. Connect the ribbed wire to the house white wire. Connect the wire with writing on it to the house black wire.
Recommended Grounding Method
1.Loop the fixture ground wire around the fixture ground screw (located on mounting bracket) once.
2.Tighten ground screw.
3.Attach end of fixture ground wire to the bare ground wire inside the junction box using sup- plied wire nut.
If you are uncertain about the grounding method, consult your local building code.
Fixture Ground Screw
Wiring Light Fixture
Note: All wiring should be run in accordance with the National Electrical Code through conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of the system.
Fixture Bare | Junction Box |
Ground Wire |
|
Black to Wire |
with Text |
1.To simplify installation, at- tach one end of
Terminal
Bare Ground Wire
Printed On It |
White to Ribbed Wire