Heath Zenith 4350 Install pendant light to Junction Box, Testing, Watts maximum each, DualBrite

Install pendant light to

Junction Box

1.Push wires into the junction box.

2.Remove S-Hanger.

3.Slide canopy onto canopy screws and tighten knurled canopy nuts securely against the canopy. Note: Canopy should fit tight against mounting surface.

Canopy Screw

Testing

1.Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes.

2.To remove sensor cover, unscrew the 4 sen- sor cover screws holding the sensor cover on bottom of light fixture.

Knurled
Canopy Nut	Canopy

Bulb installation and

replacement

Sensor

Sensor Cover

Nut

Sensor Cover

1.	Slide door latch up to unlock door. Pull latch to
	open door.
2.	Install two candelabra base light bulbs (60
	Watts maximum each).
3.	After installing bulbs, close door and slide latch

3.SettheON-TIMEswitchtotheTESTpositionand the DualBrite® switch to the OFF position.

down to securely lock door.

DUAL		BRITE
				K
			DUS WN
	3	6	TO DA
OFF
				N
			10 MI
	1	5IME
TESTON-T

Sensor

Lens

DualBrite®

DUSK

OFF 3HR 6HR TO DAWN

TEST 1 5 10 MIN

ON-TIME

Lift Latch Up Open Door

4.Walk through the coverage area noting where you are when the lights turn on. In TEST mode, light will stay on for only 5 seconds then turn off.

598-1219-05