Heath Zenith 4350 manual Specifications

2.Cut desired amount of foam tape needed to adhere the lens shield to the sensor lens.

3.Remove paper backing from one side of cut foam tape and adhere foam tape to inside of lens shield.

4.Removepaperbackingfromothersideofcutfoam tape and adhere lens shield to sensor lens.

5.Retest to confirm that the sensor is no longer false triggering.

6.After switches are set and testing is complete, use the 4 sensor cover screws to install the sensor cover.

				ITE	®
		BR
DUAL
						K
					S WN
				DUDA
		6		O
	3			T
OFF
						N
				10	MI
		5
	1
ST			IME
		-T
TE ON

Lens Shield	Sensor
	Lens

Note: To help determine amount of lens shield required, apply small sections one at a time. Ad- ditional sections can be applied if necessary.

SPECIFICATIONS

Range	Up to 30 ft. (9.1 m)
	[varies with surrounding
	temperature].
Sensing Angle	360°
Electrical Load	Up to 120 Watt
	Maximum Tungsten
	Incandescent (Up to 60
	Watt Maximum each
	lampholder).
Bulb Type	Candelabra Base, Type
	“B”, 60 Watt Maximum
Power Requirements	120 VAC, 60 Hz
Operating Modes	TEST, AUTO/ACCENT,
	and MANUAL MODE
ON-Timer	1, 5, 10 minutes
DualBrite® Timer	Off, 3, 6 Hrs, Dusk-to-
	Dawn

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

598-1219-05