Install universal Mounting
Bracket
WARNING: Turn power off at circuit breaker or fuse.
1.Removeuniversalmountingbracketfromcanopy by removing the 3 knurled canopy nuts.
2.Tighten the three canopy screws finger tight.
3.Attach universal mounting bracket to junction box securely with the two screws provided.
Junction Box
Universal Mounting
Bracket
Canopy Screw (x3)
(Tightened Finger
Tight)
Mounting Bracket
Screw (x2)
Nut 
Star Washer 
Flat Washer
Canopy
Assemble canopy
1.Determine the number of mounting rods needed to mount the pendant light. Any combination of the 3 mounting rods may be used. Note: For best performance, mount the fixture so that the sensor is between 8 and 10 feet (2.4 m) above the ground.
2.Determine which mounting rod will connect to canopy.
3.Locate the 1" (25.4 mm) threaded rod.
4.Connect the end of the threaded rod with the thread sealant to the mounting rod that will connect to the canopy. Hand tighten securely. Note: Excess sealant may have to be trimmed away for best appearance.
5.Place the small, thick, decorative washer onto the threaded rod.
6.Place the decorative flat washer onto the threaded rod.
7.Place canopy onto threaded rod.
8.Place the other large washer onto the threaded rod.
9.Place the
10.Place star washer onto threaded rod.
11.Screw nut onto threaded rod and tighten se- curely with wrench.
Decorative Flat Washer
Small, Thick,
Decorative Washer
1" (25.4 mm) Threaded Rod
End with Thread
Sealant
Mounting Rod
