11
12. Set the Pulse Support (111) on the console as-
sembly. Make sure that no wires are pinched.
Tighten two M4 x 20mm Screws (2) into the
Pulse Support (111).
Tighten six M4 x 19mm Screws (35) into the
Pulse Support (111) and console assembly.
Start all six Screws before tightening any of
them.
2
35
35
35
12
111
2
13. Have a secondperson hold the console assem-
blynear the Right Upright (89).
Connectthe Wire Harness (88) to the console
wire.See the inset drawing. The connectors
shouldslide together easily and snap into
place.If they do not, turn one connector and try
again.IF THE CONNECTORS ARE NOT CON-
NECTEDPROPERLY, THE CONSOLE MAY
BE DAMAGEDWHEN THE POWER IS
TURNEDON. Remove the long tie from the Wire
Harnessand the tie from the console wire. Then,
insertthe connectors into the Right Upright (89).
Setthe console assembly on the Right Upright
(89)and the Left Upright (not shown). Make sure
thatno wires are pinched.
89
Console Assembly
Console Wire
Long
Tie
88
13
88
Console
Wire
Console
Assembly