8
3. Remove the M10 Nut (19), the M10 x 50mm Bolt
(31), and the shipping bracket (A) from the Base
(95). Attach a Wheel (97) with the Bolt and the
Nut that you just removed. Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
31
19
A
3
97
95
4. Identify the Right Upright (89) and the Right
Upright Spacer (91), which are marked with
stickers.
Insert the Wire Harness (88) through the Right
Upright Spacer (91) as shown. Then, set the
Right Upright Spacer on the Base (95).
Withthe help of a second person,hold the Right
Upright (89) near the Base (95). See theinset
drawing.Tie the long tie in the Right Upright se-
curely around the end of the Wire Harness (88).
Then, pull the other end of the long tie until the
Wire Harness is routed completely through the
Right Upright.
4
Long
Tie
89
88
95
88
89
91
88
Long
Tie
5. Hold a Bolt Spacer (90) inside the lower end of
the Right Upright (89). Insert an M10 x 95mm
Bolt (8) with an M10 Star Washer (9) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (90), M10 x
95mm Bolt (8), and M10 Star Washer (9).
Hold the Right Upright Spacer (91) and the
Right Upright (89) against the Base (95). Be
careful not to pinch the Wire Harness (88).
Tighten the M10 x 95mm Bolts (8) until the
heads of the Bolts touch the Right Upright; do
not fully tighten the Bolts yet.
91
89
88
9
90
8
5
95