4.Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the Incline increase or decrease button, or one of the incline buttons numbered 0 to 10. Each time you press one of the buttons, the incline will gradually change until it reaches the selected incline setting.
. Select a display mode and monitor your progress with the display.
The console offers several display modes. The dis-
play mode that you select will determine which workout information is shown. To select the de-
sired display mode, press the Display button re- peatedly.
As you walk or run on the treadmill, the display can show the following workout information:
-The incline level of the treadmill.
-The speed of the walking belt.
-The distance that you have walked or run.
-The elapsed time.
-Your pace in minutes per mile or minutes per kilometer.
-The approximate number of calories you have burned.
-Your heart rate (see step 6 on this page).
Regardless of which display mode you select, the speed and incline settings will appear in the display for a few seconds each time you change the setting.
6.Measure your heart rate if desired.
Before using the handgrip
pulse sensor, remove the
sheets of clear
plastic from the metal con-
tacts. In addi- tion, make
sure that your hands are clean.
To measure your heart rate, stand on the foot
rails and hold the
hands. When your pulse is detected, your heart rate will be shown, For the most accurate heart
rate reading, continue to hold the contacts for about 15 seconds.
. When you are finished exercising, remove the key from the console.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest set- ting when you fold the treadmill to the storage position, or you may damage the treadmill.
Next, remove the key from the console and put it in a secure place.
When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. IMPORTANT: If you do not do this, the treadmill's electrical compo- nents may wear prematurely.
17
