4.Slide the Handlebar Collars (12) onto the Handlebars (6). Attach the Handlebars to the Scissor Frame (3) with eight M5 x 12mm Screws (19). Next, slide the Handlebar Collars down over the Screws.
5.The Console (48) requires two AA batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Remove the battery door from the Console. Press two batteries into the bat- tery compartment. Make sure that the negative ends of the batteries (marked ÒÐÓ) are touching the springs in the battery compartment. Reattach the battery door.
Slide the Console (48) onto the console plate. Make sure that the plastic clip on the back of the Console snaps into the tab on the console plate.
Connect the console wire to the Reed Switch Wire (49).
6.Identify the Left Pedal (8). (The Left Pedal is marked with an ÒL.Ó) Using an adjustable wrench, tighten the Left Pedal counterclockwise into the left arm of the Crank (53).
Tighten the Right Pedal (9) (not shown) clockwise into the Right arm on the Crank.
4 |
|
| 6 |
12 | 12 |
| |
19 |
|
| 19 |
| 3 |
5 |
|
| Console |
| Wire |
48 |
|
| 48 |
Console | 49 |
Plate |
|
| Batteries |
| Battery Door |
6 |
|
8 |
|
| 53 |
| 3 |
7.Make sure that all parts are properly tightened before you use the exercise cycle.
5
